Omnicor - NuTAP (10/100 Base-T) - NuTAP analyzer Interface RJ45 x 8

NuTAP (10/100 Base-T)

NuTAP analyzer Interface RJ45 x 8

NuTAP provides a safe, secure and cost-effective way for the deployment of IDS sensor into full-duplex links by aggregating both directions of the full-duplex streams on up to 4 different network segments into a single 1000Mbps monitoring port. The IDS sensors could then see both conversations on each side of the monitored network segments with only one interface. Because the IDS sensor is hidden behind the TAP, it’s shielded from direct attacks from the link being monitored.

Features
1 x 3 LEDs for NuTAP status, including Power, System and Blank/Oneshot.
1 x 3 LEDs for real-time link status of monitor port, including 10/100M or 1000M link speed and Act/Link status.
8 (ports) x 14 (status)LEDs for real-time display of traffic events including packet types, collisions, and errors.
Active TAP based on store-and-forward architecture.
Built-in filter for redirecting traffic from specific network port(s) to the monitoring port via 8 dip switches.
Firmware and FPGA are upgradeable via RS-232 port.
Supports Power-over-Ethernet devices.